No products
Welcome to 3FVape
Are you 21 or older? You must be 21 or older to enter our website.
The New Innokin iTaste MVP boasts 20 Watts of Intelligent Power! The large capacity of the internal 2600 mAh battery means you can depend on its long lasting power. And it doubles as a backup portable charger that can power your mobile phone and other electronic devices. The iTaste MVP 20W is smarter with a 32-bit ARM microprocessor which means far faster data processing power and superior performance.
3FVAPE Recommended Products:
Earn up to $50 through our Product Review Program.
Brand | Innokin |
Color | Black |
Model | iTaste MVP |
Product Type | VW |
Battery Capacity | 2600mAh |
Material | Aluminum Alloy |
Thread Type | 510 |
Variable Voltage (VV) | No |
Battery Type | Fixed |
Telescoping Mod | No |
Power Output | 6~20W |
Variable Wattage (VW) | Yes |
Package | 1 x Mod |
Weight | 161g (5.68oz) |
Depth | 41mm (1.61 inch) |
Height | 107mm (4.21 inch) |
Width | 22mm (0.87 inch) |
Shipping Type | Built-in Battery |
The MVP 20W is the newest in the line of bestselling Innokin Technology iTaste MVP izers and features a wider range of Variable Voltage and Wattage, advanced safety features, a long lasting 2600mAh battery, while you charge technology and the MVP20W can also be used to charge your mobile phone and other electronic devices.
The Primary Features of The MVP20W:
Variable Voltage:
Variable Voltage: can be adjustable from 3.3 volts to 7.5 volts in 0.1 volt increments.
Variable Wattage:
Variable Wattage: can be adjustable from 6.0 watts to 20.0 watts in 0.5 watts increments.
Battery Level Indicator:
The MVP 20W battery capacity is displayed via green, yellow and red LED.
Green = Almost fully Charged. When the MVP 20W fully recharged the LED light will power off.
Yellow = Half Power.
Red = Low Power. Charge the MVP 20W.
Large battery capacity:
The MVP 20W has a built-in 2600mAh polymer Li-Ion rechargeable battery.
ON/OFF battery switch:
Press the power button three times in rapid succession to turn on the MVP 20W. When the MVP 20W is powered on Hold down the button to activate the atomizer and . When the MVP 20W is not in use, press the button three times in succession to power off the MVP 20W Advanced Personal izer. Always power off the MVP 20W Advanced Personal izer when it is not being used, or when it is going to be stored in a pocket, bag or purse.
Ohms meter:
Reads the resistance of your atomizer / cartomizer / clearomizer.
Puff Counter:
The integrated Puff counter will record the number of puffs you have taken. Either press "P" button or "U" button for 1 second to check the number of puffs. The Puff Counter will reset to 0 whenever the device is powered off.
SAFETY:
10 second Cutoff:
If the activation button is held for longer than 10 seconds the MVP20W Advanced Personal izer will stop firing until the button is released and pressed again.
Low Voltage Warning:
The Red LED and Battery bar will continue blinking when the battery capacity is lower than 3.3V and the MVP 20W Advanced Personal izer will power off automatically.
Short Circuit / Atomizer Protection:
Short Circuit / Atomizer Protection protects the MVP 20W Advanced Personal izer against shorted atomizers and will stop the unit from functioning in unsafe conditions.
Over-Discharge Protection:
The MVP 20W Advanced Personal izer monitors the battery voltage and will automatically power off when the battery is discharged.
" while charging" Technology:
The MVP 20W is recharged with a Micro USB cable. When plugged into a power source the MVP 20W can also be d and charged at the same time with Innokin Technologys " while you charge" pass-through technology.
Remembers last Voltage or Wattage setting:
When the MVP 20W is turned off it will store the current voltage or wattage setting and it will retain the setting when the MVP 20W is powered on.
Built-in 3 digit display:
Digital display shows the Ohms meter, Voltage / Wattage setting and the number of Puffs taken since last time the battery was turned off.
Portable power source for electronic products:
To charge your portable electronic device with the MVP 20W: set the small pin switch on the bottom of the MVP 20W to the ON position and connect a micro USB cable to the USB OUTPUT port (DC 5V, maximum output current 0.5A)To maximize the battery charge of your MVP20W please ensure that the bottom switch is set to the Off position when you are not using the portable charger function.
Technical Specifications:
Operating Voltage: 3.3V~7.5V;
Operating Wattage: 6.0W~20W;
Standby current: 100uA max.;
Maximum output Wattage: 20W;
Maximum output Current: 6A;
Maximum output Voltage: 7.5V;
Clearomizer Resistance: 1.0 Ohm (minimum);
Battery: Built-in 2600mAh polymer Li-Ion rechargeable battery;
Charging: Micro USB DC 5V / 1000mA;
OUTPUT port: DC 5V / 1000mA
3F is a professional retail, wholesale and dropship online shop. We provide new and cool products at affordable price. We have overseas warehouse for you for fast delivery.
and other questions regarding this product, just contact us. We also encourage you to leave review of products on 3F.